XT-K180 型全自動薄膜捆扎機

XT-K180 Full-automatic Film Strapping Machine

工作原理：

  1盒子經輸送皮帶進入積盒架。

  2當盒子疊加達到設定的數值時，推盒汽缸開始工作，把多層盒子由積盒架推*板，同時拉動捆包膜，壓盒板向下壓緊盒子后推盒汽缸退回。

  3推盒汽缸退回后上熱封板開始工作，當汽缸向下作用時同時拉動捆包膜并壓緊捆包膜，下熱封開始工作，切斷并熱封住捆包膜。

  4熱封完成后，上下熱封汽缸及壓盒汽缸復位，一次捆包完成。

  5當推盒汽缸復位后頂盒汽缸立刻工作，當上下汽缸復位時疊盒動 作已經完成，開始下一次捆包！

XT-K180 型全自動薄膜捆扎機

Operating principle:

1 Boxes enter box- accumulating shell via conveying belt.

2 Box-pushing cylinder starts to push boxes onto upper plate from box-accumulating shell when boxes reach set number and draws box-strapping film at the same time. Box-pushing cylinder will go back after box-pressing plate compresses boxes.

3 Upper heat-sealing plate starts to run after box-pushing cylinder goes back. Box-strapping film is being drawn and compressed while box-pushing cylinder is going back, next, bottom heat-sealing begins to cut and heat-seal box-strapping film.

4 Upper and bottom heat-sealing cylinder reset after finishes heat sealing, that is to say, one box strapping is finished.

5 After the resetting of box-pushing cylinder, box-peaking cylinder starts to work at once. Box-stacking will be finished after upper and bottom cylinders reset, then the next time of box strapping will begin.

產品介紹

1、設備型號：XT-K180型

2、產品概述：該機采用進口電氣元件，PLC控制系統、人機操作界面、具有運行穩定、操作簡單等特點；主要用于食品、藥品行業盒裝產品的組合捆扎。

Product introduction

1、Type：XT-K180

2、Overview: this machine runs stably and is easy to operate with the use of imported electrical elements, PlC control system and human-machine operation surface, used to strap combinedly products packaged with boxes in food and medicine industries.

技術參數Technology parameters：

XT-K180 型